[TR] Engine stand

[Stan Foster]

I used 4 grade 8 bolts for both my TR6 and TR3 engines (two into the block, two with nuts if I recall). The stand gave a little under the weight but I was never afraid of the bolts letting go or the stand tipping over.

Stan

-----Original Message-----
From: Triumphs <triumphs-bounces at autox.team.net> On Behalf Of Bob Nogueira
Sent: Tuesday, October 23, 2018 2:15 PM
To: Triumphs list <Triumphs at autox.team.net>
Subject: [TR] Engine stand

I’m about to rebuild my TR 4 engine. I’ve done it three times in the past so there’s not much I’m worried about. The one thing that freaks me out is suspending the engine on the engine stand by four 5/16 inch bolts. Every time I see it sitting there I freak out that the bolts are going to snap and the engine is going to come crashing down.
    Two things I’ve done to relieve my paranoia is add a cross beam on the front so it has four wheels not the original three and keep a two by four between the front of the engine and the leg to carry the weight of the suspended engine.
      Two questions, am I being paranoid and should I use grade 5 or grade 8 bolts to fasten the engine to the stand?

Thanks for any advise.

Bob Nogueira 
** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/stan@redtr6.com