[TR] [EXTERNAL] - making the mating surface of an oil pan flat

[David Templeton]

Hammer and some kind of drift/block for me.  And tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap, tap 😊

From: Triumphs <triumphs-bounces at autox.team.net> On Behalf Of Sujit Roy
Sent: Monday, January 21, 2019 1:47 AM
To: Triumphs <triumphs at autox.team.net>
Subject: [EXTERNAL] - [TR] making the mating surface of an oil pan flat

  The PO put gallons of sealer around the pan/ sump and over tightened all the bolts. They are all raises and .if  I put a flat rule between holes, I  can notice at least 1 or more mm gap.

I am thinking of using a nut and bolt with a few washers to hopefully make the bolts holes flat again. Are there any other good simpler ways to do this. I don't want to hammer them as I think I will do more damage.

Sujit

--
Sujit Roy
Cupertino, California

https://triumphstagblog.wordpress.com/<https://urldefense.proofpoint.com/v2/url?u=https-3A__triumphstagblog.wordpress.com_&d=DwMFaQ&c=ZgVRmm3mf2P1-XDAyDsu4A&r=346MKQty4J9yevdUa9Fj_cT53y_74TwSRM-I7J2SFzs&m=I7Ee-UhTqwpXumXQ2MVknb6dN3Yavj0q9t_WIRmGmR0&s=g9cXoof_5rNbAsAzIROW15LDCi-vS5BJQlRPi_k9Sc4&e=>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20190121/266519e0/attachment.html>