[TR] Oil flow to rocker assemble

[Roger Elliott]

With out going into detail, I have had problems with the rocker assembly 
on a rebuilt GT6 Mk1 engine with a new rocker shaft and rockers and push 
rods.

I would like to verify I have good oil flow before I go any further.  I 
know that there is not a lot of oil going through it, but I want to make 
sure I have some.

My question is this, if I spin the oil pump with a drill (CCW) will it 
always get oil to the rockers, or does the cam shaft have to be in a 
particular position for the oil to get the the rockers?

If the cam needs to be in a specific position, is there a way I can tell 
where that should be easily?

Thanks,
Roger