In a message dated 97-03-04 20:48:31 EST, GROSS(at)UNIT.COM (Jarrid Gross (Yorba
Linda, Ca)) writes:
>A larget socket would obviuosly be nice, but I use a vise-grip locked
>around the area
>that sticks out of the crank pully.
>
>Put the car in 4th gear with the e-brake on "This locks the engine".
>A carefull whack with a lead hammer in the counter-clockwise direction
>will likely unlock the bolt.
>
>Find a correct fitting socket, cause you'll need it for tightening the
>bolt to the 160 to 180 lb ft spec. later.
>
>
Sounds like the ticket for loosening the Whitworth-sized bolt. But what
about tightening it?
Does anyone have any ideas on how to secure the engine (in the car,
preferably with the pan still on) and torque the bolt down to 160-180 lb ft
before the clutch starts slipping?
Dick Sanders
Series V x 2
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:36:19 CDT