RE: Head Gaskets (was Boiling oil)

From: William West (Will_Thane(at)msn.com)
Date: Fri Jun 20 1997 - 22:48:39 CDT

Next message: Russell Maddock: "Re: Need a Blank ID Plate"
Previous message: William West: "Head Gaskets (was Boiling oil)"
Maybe in reply to: William West: "Head Gaskets (was Boiling oil)"
Next in thread: Sergio Dimarmo: "Re: Head Gaskets (was Boiling oil)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Greetings!

Sorry, I was in error in the description of the head gasket for the Humber.
Don't know what I was thinking of (maybe my MG???) Anyways, the head gasket
for the humber appears to consist of two thin sheets of copper sandwiching a
fiberous material. The gasket has been dented on one edge, taking up about
two inches of length and bending inward about a quarter inch of material. The
copper/fiber sandwich has separated at this point. Is this gasket unuseable?

Thanks again!

Will

Next message: Russell Maddock: "Re: Need a Blank ID Plate"
Previous message: William West: "Head Gaskets (was Boiling oil)"
Maybe in reply to: William West: "Head Gaskets (was Boiling oil)"
Next in thread: Sergio Dimarmo: "Re: Head Gaskets (was Boiling oil)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:44:43 CDT