From: EJMW(at)aol.com
>Whilre dealing with my gas tank woes I have found that my sensor has
some
>fluid in the float.
>
>Does this mean it has a leak as well or did they put some fluid in the
float
>for proper weighting?
>
>Any info appreciated.
There should be no fluid inside the float.
Easy to fix though.
1) drill a very small hole into the float (I mean really small).
2) Drain the fuel out through the hole.
3) Clean the outside of the float with a good solvent.
4) Use a torch and silver solder (use flux too) to re solder the float.
5) Use the silver solder to patch the small hole you drilled.
Make sure all the joints are shiny and very clean, or else you'll
be back to square one in no time.
Jarrid Gross
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:07:11 CDT