In a message dated 11/30/98 7:46:04 PM Eastern Standard Time,
paul.heuer(at)dsto.defence.gov.au writes:
<<
Thanks Jim,
Someone a while back told me the hole in the floor was different for
synch & non-synch trans. I ass-umed it was the position, but maybe he
was talking about the diameter of the hole. Is it the same for both?
Anyone know the diameter of the non-synch shift lever? Can you visually
tell the diff b/w the two boots?
>>
Paul,
I'm pretty sure the holes were the same size on the cover panel that fit on
the
trans tunnel. I measured a 1-4 shift lever and where it counts it's about
9/16.
Can anybody measure a 5 ?
Jim
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:22:35 CDT