Ball joints and bushings

From: Andrew K Boetticher (a_boetticher(at)juno.com)
Date: Fri Feb 05 1999 - 00:00:23 CST

Next message: steve sage: "Sunbeam Salton Sea Tailgate Drive And Adventure!"
Previous message: Robert Wiseman: "Re: Photographs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi all,

Has anyone taken the time to fabricate the various support tools, driving
tools and slotted support tools needed to remove/replace the upper ball
joints and fulcrum pin bushings on a Series IV, and if so, would you be
willing to sell/rent/loan them? I was gathering all the necessary
measurements tonight in anticipation of paying a local machinist to fab
them, then thought someone else may have the necessary equipment lying
around in the back corner of their shop.

Alternatively, does anyone know of a good shop in the Seattle area with
some knowledge of Sunbeams that can be trusted to do this type of job?

Thanks,

Andy Boetticher
Seattle

Next message: steve sage: "Sunbeam Salton Sea Tailgate Drive And Adventure!"
Previous message: Robert Wiseman: "Re: Photographs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:34:19 CDT