Jerome,
I wont be in my car again until Wednesday. I'll make myself a note to look and see what
I find. I dont remember there being an end. I'll see what I find.
Right now my turn signals dont work. Those wires were fried. I have tried to recreat
them but so far not successfully. My Series I has a really flimsy type turn signal
switch. As far as I can find out it is not replaceable as is. I have fabricated the
metal parts and thought I did a really neat job but there is still a short somewhere in
the wiring. I have decided to wait to fix that until I get it on the road.
Rob
Jerome Yuzyk wrote:
> Robert Wiseman <rob(at)wisemaninsurance.com> wrote:
> > Jerome,
> > My wiring is all covered with electrical tape also. However, as I inspect it, it
> > all seems to match the color codes in the manual. I do have a few spots under the
> > dash near the steering column where the exterior is burned. The wires inside seem
> > okay. The only electrical items I dont have working yet are the heater blower and
> > the turn signals.
>
> It is my switches that do not match. They have too many wires on them,
> according to the diagram. Do yours match? What do you have exiting the
> very end of the harness, where the turn signals exit?
>
> --
>
> - J e r o m e Y u z y k | jerome(at)supernet.ab.ca -
> - BRIDGE Scientific Services | www.tgx.com/bridge -
> - Sunbeam Alpine Series II #9118636 | www.tgx.com/bridge/sunbeam -
> - I'm going to SUNI III... Are You? | www.newsource.net/suni3 -
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:34:35 CDT