Hi All,
I'm e-mailing you guys because all of us had expressed interest in the
badges that Paul Heuer's club makes. As you may know, I sent a post
stating that I'd talked to Rick about badges for this purpose and he
said he had some that'd fit the bill. They are part of a 2 piece badge
that goes on the rear fender of Tigers. The part we'd be using is 1.5"
in diameter, is round and has the Rootes "hound" on it; there is no
writing on it, just a picture. It has two metal tabs on the back that
fold over to hold it onto (with silicone) the other part of the badge.
Now, while this badge is not specifically designed to be used as a
hubcap badge, I don't see why it can't be. When mounted with the tabs
and some silicone, it should be secure on the cap. Also, Rick quoted
that the price was "around $4," so the price is significantly less than
it would be if we bought the ones from Australia.
So, my question is, what do you all want to do? Paul is holding off on
the run of badges until we decide where we're going to get them from.
Since I offered to be the front man for the Aussie deal, I figured I'd
find out what the consensus is.
Christopher
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:41:04 CDT