oil-pump shaft cuts through oil galley

• Next message: Paul Rische: "Re: Alpine restoration using CocaCola-somewhat car content"
• Previous message: Jerome Yuzyk: "crimped timing chain oil pipe"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

In case anyone wants to know...

There was some chat a little while ago about how the shaft of the oil
pump cuts through an oil galley. I checked my 1592cc block and it does,
creating a horizontal oval opening that is 0.8" wide and 0.5" high.

I am still wondering whether I should "goop the (oil pump) shaft."

-- 
-              J e r o m e   Y u z y k | jerome(at)supernet.ab.ca          -
-           BRIDGE Scientific Services | www.tgx.com/bridge             -
-    Sunbeam Alpine Series II #9118636 | www.tgx.com/bridge/sunbeam     -
-    I'm going to SUNI III... Are You? | www.newsource.net/suni3        -

• Next message: Paul Rische: "Re: Alpine restoration using CocaCola-somewhat car content"
• Previous message: Jerome Yuzyk: "crimped timing chain oil pipe"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:41:14 CDT