Kurt wrote,
>I think that I have figured out the answer to my own question. I think that
>I need to connect one end of the Pertonix unit to the coil and the other
end
>to the ignition switch but then I don't hook the ignition wire to the coil.
>Does this sound right?
If you had a ballast resistor the schem would look like this.
If you have + gnd, the colors might be different, and coil+/- are reversed.
|<- To ignition sw.
|<- (Pertronics red)
/
/
\
\<- 1.2-2.0 ohm ballast
/
/
\
\
|
|<-Coil+ (neg GND)
{---}
{ }
{ }
{ }<-Coil
{ }
{ }
{---}
|<-Coil- (neg GND)
|
|---------------( Pertronics blue) or points
Jarrid
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:45:43 CDT