iwander(at)worldnet.att.net writes:
>Might as well go all the
>way and pull the engine to clean out the metal particles, make sure you
>have
>the block line bored? to clean out the oil passages. Also wouldn't be a
>bad
>idea to have the pump check for tolerance. Going the extra mile now will
>prevent you from (hopefully) any future headaches.
Yes, I have partially disassembled the engine for cleaning, or at least
the machine shop has. They are replacing the rod bearings, the ysay
the mains are ok. It was line bored during the rebuild. I have
purchased a new oil pump and lifters. Hopefully there will not be an
encore performance.
CNA
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:51:34 CDT