I found this in my archives. It matches what I did with army canvas.
-------- Forwarded message --------
Date: Sun, 12 May 1996 18:05:10 -0400
From: OldeAlp(at)aol.com
To: alpines(at)autox.team.net
Subject: Rebound straps
This question came up a few weeks ago, now I can give some answers.
The strap is 22" long by 1 1/4" wide. It is made up with a core of 1' wide
woven webbing wrapped in a wider piece folded in three, giving a 4 layer
finished strap. The ends attach under the buffer bracket using what Rootes
calls a lock washer - a 1' x 1 1/4" piece of thin sheet metal with 30 1/16th
inch holes punched in it - half from each side - to give a cheese grater
effect.
There seems to be a lot of slack, but it becomes taut with two inches of axle
drop. On the side with the broken strap, it dropped 2 5/8" before the
springs, shocks, whatever stopped it. These observations were on an empty
car sitting in the garage. The dynamics of power, motion, and load were not
considered - mainly 'cause I don't have a clue as to how to do that.
Caveats- the straps on my Series 2 are not factory - they were obtained from
Rick McLeod about 1982 but seemed right. My shock absorbers were rebuilt by
Apple Hydraulics about six years ago - the one on the side with the good
rebound strap is now leaking. The springs and bushings have never been
touched - but probably should be.
The broken strap shows signs of a lot of friction before it went away. Guess
the rear axle windup from all of those power launches took its toll.
"Ole"
--- J e r o m e Y u z y k | jerome(at)supernet.ab.ca - - BRIDGE Scientific Services | www.tgx.com/bridge - - Sunbeam Alpine Series II #9118636 | www.tgx.com/bridge/sunbeam - - I went to SUNI III... Did You? | www.newsource.net/suni3 -
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:35:41 CDT