Greg Locke wrote:
> So the crank itself is not in danger of breaking at these revs? Did you
> treat it in any way? I've also heard of steel center main bearing caps being
> a must.
Not sure, my 7000 RPM engine is hanging in there.
Some people have even gone to having a billet steel crank made up.
> Did these rods still fit down the bore, or did you have to assemble from the
> bottom of the engine?
>
No, I'm sorry to say they did not fit in the bores.I had to assemble the pistons
through the bottom, and used
teflon buttons for the piston pin retainers.
Jarrid Gross
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:45:13 CDT