I have my new tranny all ready to go. Bearings ,seals and elbow grease.
Now here it is. When I replaced the bushing in the release bearing fork.
And go to thinking as I turned around. Does' the angle point towards or
away from the transmission?
Or if you set the mount flat on the table and the long part of the
fulcrum in your right hand would the release bearing end angle up or
down..
I can't draw it the way I want. So ?
chuck
series ll
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:47:38 CDT