Steve, I just measured mine and it was 30 5/8", from outer edge to outer
edge of the U-joint holes. Russ
----- Original Message -----
From: "Steve Shuttleton" <packit(at)erols.com>
To: <alpines(at)autox.team.net>
Sent: Tuesday, March 28, 2000 8:23 AM
Subject: driveshaft for od trans
> Hi everyone! I finally found an overdrive transmission for my series IV !
> Of course I'm very excited about finally having an almost fully optioned
> Alpine ( Only missing a Clock)
> Anyway, I have been informed that my standard driveshaft is not going to
> work with the overdrive. Now for the fun part: Does anyone out there have
an
> overdrive drive shaft or can tell me how much the standard driveshaft
needs
> to be shortened to fit?
> Thank you , look forward to your responses.
>
> Regards,
> Steve Shuttleton
>
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:53:02 CDT