VB Alloys

From: Scott Donnelly (oharajem(at)free.midcoast.com)
Date: Fri Jul 21 2000 - 10:47:46 CDT

Next message: Christopher Albers: "Re: VB Alloys"
Previous message: Christopher Albers: "Re: VB Alloys"
Next in thread: Christopher Albers: "Re: VB Alloys"
Reply: Christopher Albers: "Re: VB Alloys"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I had to do a little machining on the front hubs to get them fit
properly.
Spacing on fronts is fine w/ 185-60-14s. I wish the rears were a little
wider...
Scott Donnelly
SV

Next message: Christopher Albers: "Re: VB Alloys"
Previous message: Christopher Albers: "Re: VB Alloys"
Next in thread: Christopher Albers: "Re: VB Alloys"
Reply: Christopher Albers: "Re: VB Alloys"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:05:51 CDT