Hmmm. Itchy trigger finger. The rest is:
..any kind of axle locating device and hard cornering the retaining pin can
shear and the axle tubes inch out.
-----Original Message-----
From: Bill Babcock
Sent: Friday, August 04, 2006 3:14 PM
To: 'N197TR4@cs.com'; fot@autox.team.net
Subject: RE: [FOT] TR3A Axle-Available for Southwick Conversion-Free
Actually, I need one for the Ambro, but I have a bunch of them and so don't
feel great about taking a part someone else might need. Perhaps we can do it
this way (assuming no one on the east coast needs an axle). When and if
anyone needs a TR3/ solid rear end just give me a shout and one of mine is
theirs.
BTW, you might suggest to Southwick that while the rear axle is all nice and
clean that they weld the axle tubes to the banjo. If you start putting a lot
of pressure on the part with a
Bill
-----Original Message-----
From: owner-fot@autox.team.net [mailto:owner-fot@autox.team.net] On Behalf
Of N197TR4@cs.com
Sent: Friday, August 04, 2006 11:22 AM
To: fot@autox.team.net
Subject: [FOT] TR3A Axle-Available for Southwick Conversion-Free
List...if you were thinking about doing a Southwick Conversion for a TR3A, I
have one available.
I would make arrangements, one way or another, to get it Southwick and save
you shipping costs one way.
This axle was given to me by FoT John Houlton and I will pass it on, in
kind.
Regards,
Joe (A)
|