Hi, you might try Richard Good (610 777-4457). He uses 300ZX diffs with some
of his hub/axle setups. He may have a source(s) for the calipers or info on
where to get them.
Good luck,
Bill Tobin Erie, PA TR6
----- Original Message -----
From: "Joe Boruch" <jaboruch@netzero.net>
To: <fot@autox.team.net>
Sent: Friday, January 04, 2008 1:20 PM
Subject: [Fot] 300ZX Calipers
> Anybody on the list have any contacts in the Nissan 300ZX community? I am
> looking for 1 or 2 Aluminum calipers for a 1990 (up to 7/1990) 300ZX.
This
> are for a 26mm rotor and were used on non-turbo cars. They are part #'s
> 41001-30P00 and 41011-30P00 (right and left). I am looking to see if I
can
> adapt these to fit my TR3 and then if so, get the SCCA to allow them. I
have
> already gotten a verbal approval that SCCA will allow an aluminum caliper
from
> a production vehicle. We (including Sam Halkias) have been trying to get
SCCA
> to allow any caliper (Wilwood), but for years they have not budged on
that,
> insisting that production car calipers only be used up front.
>
> Yes, these are available rebuilt on the internet from a number of
suppliers,
> but I don't want to spend the big $ on them just to try and see how close
they
> are to fitting. Once I know they can be made to fit then I can buy some.
The
> 300ZX ones seem to be the closest fit that I have found by researching
> dimensions. Joe(B)
>
> _____________________________________________________________
> Get your fix. Click here for reliable handyman services!
>
http://thirdpartyoffers.netzero.net/TGL2211/fc/Ioyw6ijn3cIUJTuqLxXYn273SUUM5
3
> kQgL3ruY4ihIQ69zfnY6sMLQ/
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|