fot
[Top] [All Lists]

Re: [Fot] Thanks Chuck...Scraper & Windage Tray Project-Status

To: N197TR4@cs.com
Subject: Re: [Fot] Thanks Chuck...Scraper & Windage Tray Project-Status
From: "Chuck Arnold" <triosan@gmail.com>
Date: Thu, 5 Jun 2008 09:16:19 -0700
Forgot to mention, the one thing that made installing it while engine in the
car is that I have switched to using studs and nuts to hold on the pan.  The
studs allow the scraper and spacer to be held in place when installed to
there is a way to place them in and then install the pan with the windage
tray in it.

There are pictures of my first install [engine out] are at:

http://picasaweb.google.com/Triosan/WindageTrayScraprerAndStuds

Chuck

On Thu, Jun 5, 2008 at 8:35 AM, <N197TR4@cs.com> wrote:

> Chuck....Since I have no experience yet, this is encouraging and useful
> information....and thanks for breaking the ground on this feature.
>
> Joe Alexander
>
>
> Just an update.  A couple of years ago I got the first one from
> crank-scrapers [they used my oil pan, oil pump and rod and their
> block/crank].  Went in when the engine was out.  There was a little
> interference on the tray, but the grinder fixed that straight away.  I was
> concerned when I assembled it that the interference with the oil pump on
> install would not allow me to remove the oil pan with the engine in the car.
>
>
> I just recently got the new unit.  Installed it with the engine in the car.
>  Included the teflon scrapers.  Went in very easy.  Just had to relieve two
> small places where the scraper hit some part of the crank.  Very pleased.
>  No interference on the tray.
>
> Chuck
>
>
>
>


-- 
Chuck Arnold
_______________________________________________
http://www.team.net/donate.html

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot


<Prev in Thread] Current Thread [Next in Thread>