fot
[Top] [All Lists]

Re: [Fot] Beware of Moss figure eight gaskets

To: <toodamnfunky@comcast.net>, <fot@autox.team.net>
Subject: Re: [Fot] Beware of Moss figure eight gaskets
From: Tony and Annie Garmey <horizonracing@msn.com>
Date: Sat, 12 Sep 2009 15:19:38 -0700
If you were to torque the head down.......then remove it......won't the copper
crush? were as the steel gaskets stay "about" the same.

> From: toodamnfunky@comcast.net
> To: fot@autox.team.net
> Date: Sat, 12 Sep 2009 14:11:36 -0600
> Subject: [Fot] Beware of Moss figure eight gaskets
>
> FoT/ FYI,
>
> The copper figure 8's that would come with the standard gasket set are .006
> thicker
>
> than the shim steel gaskets. I was just about to fit the cylinder head when
> I thought
>
> I'd give it a check. Sure enough, way too high.
>
> I almost took it for granted as on the last build I had the block decked
and
> the liners
>
> machined to exactly .004 proud. Wish I would have had that same thought
> before I
>
> put the pistons in but disaster averted nevertheless.
>
> It's likely many of you already knew this but it's new to me.
>
>
>
> Jim G
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> You are subscribed as horizonracing@msn.com
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot

_______________________________________________

Support Team.Net http://www.team.net/donate.html

http://www.fot-racing.com


Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>