There is an ARP that have splines that slightly to large. I turn them on a
lathe to make the spline fit and then put a touch of weld on the back side as
security.
Bob
---- Joe Curry <spitlist@cox.net> wrote:
> Brad,
> If you go metric, it will open a whole wealth of options. Take an old stud
> to your local auto parts store and ask to look in their Dorman's catalog.
> You will look for the one that fits the shank and is the length you want.
>
> Joe C.
>
> -----Original Message-----
> From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
> Behalf Of Brad Kahler
> Sent: Monday, May 03, 2010 5:20 AM
> To: Friends of Triumph
> Subject: [Fot] 7/16 TR4 rear wheel studs
>
> Amici,
>
> I'm looking for some longer rear axle (stock axle & hub) wheel studs
> for my TR4. I would like some that are about 2" long that are 7/16-20
> thread that would replace the stock wheel studs without modification.
>
> Any suggestions?
>
> Thanks,
>
> Brad
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/fot/spitlist@cox.net
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/fot/rdavis4@cfl.rr.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|