Chuck
I have had the same problem many times even when using a dummy shaft.
I did have some success on the last one by gently moving it into place
with a screw driver.
Did you use lots of sticky grease on the case side to keep it in place?
Glenn
On 1/20/2013 11:37 PM, Chuck Arnold and/or Kathleen Kelley wrote:
> spent the afternoon reassembly the tranny for my TR6. All went OK till I
> tried to put the countershaft back in. The front thrust washer is hanging
> down about a 32 of an inch and nothing I have tried can move it up that
> little amount so the counter shaft can come through. I presume the washer
> has rotated a little such that the dimple is now not aligned with theslot
> at the top. anybody have any experience with solving this short of taking
> it all apart again and reassembling?
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/gaf3@charter.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|