fot
[Top] [All Lists]

Re: [Fot] TR4 diff disassembly

To: Scott Janzen <Janzen@REcatalyst.com>
Subject: Re: [Fot] TR4 diff disassembly
From: Todd Redmond <alfetta95@optonline.net>
Date: Fri, 27 Sep 2013 08:30:38 -0400
Cc: 'Friends of Triumph' Triumph <fot@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: fot@autox.team.net
References: <E2B96463-DFD0-46D2-9DAF-5F008327F7B5@REcatalyst.com>
The rope trick works

Tie a rope to the carrier and hang the entire axle from a vise.  Use a soft 
faced hammer and hit the the housing on both sides of the carrier. The housing 
will drop to the floor.   Note:  don't hang it too high off the ground!!  

Todd

Sent from my iPad

On Sep 26, 2013, at 10:12 PM, Scott Janzen <Janzen@REcatalyst.com> wrote:

> So, i am pulling apart the rear axle to send it to Southwick for conversion.  
> I'm working without a shop manual - and want to pull the differential out of 
> the housing.  I've removed the bearing caps.  Do I need Churchill Spreader 
> xyz, and is there a good/cheap substitute?  It does not want to pop out with 
> the persuasion of a pry bar.
> 
> BTW, there's a Detroit locker . . . any special instructions?
> _______________________________________________
> fot@autox.team.net
> 
> http://www.fot-racing.com
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/fot/alfetta95@optonline.net
> 
> 
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>