land-speed
[Top] [All Lists]

Re: Small Braided line

To: <ARDUNDOUG@aol.com>, <land-speed@autox.team.net>
Subject: Re: Small Braided line
From: "Keith Turk" <kturk@ala.net>
Date: Sat, 9 Sep 2000 22:20:31 -0500
Doug you nailed the exact Problem.... my -3 is slightly larger then the
associated parts...

I took a sanding roll and lightly worked the opening taking out a bit less
then .005 and the whole thing semi slipped together... ( following your Vise
and Tap option )

Remind me in the Future NEVER to mess with -3 line... wow YUCK!!!

Sure wish I had me some Push Rods... I would make some Noise tomarrow... oh
well

Keith ( this from a Motor that is still sitting on the engine stand... but
it's ready to go in and that is the simple part!! )
----- Original Message -----
From: <ARDUNDOUG@aol.com>
To: <land-speed@autox.team.net>
Sent: Saturday, September 09, 2000 8:35 PM
Subject: Re: Small Braided line


> In a message dated 09/09/2000 5:51:28 PM Pacific Daylight Time,
kturk@ala.net
> writes:
>
> <<
>  There has to be some secret you folks are keeping from me... this -3 line
is
>  the biggest pain in the butt I have ever seen....
>
>  Okay so Give up the Secret Chant....   What is the Pass word?   JUST HOW
AM
>  I SUPPOSED TO HOLD MY LIPS?
>
>  K ( now I can eat my dinner and go back to work... Leaving those lines
>  un-done till I chill a little )
>   >>
> Keith,
>     With the #3 there are two areas to be careful with. First, like all
> braided line, put masking tape around the area to be cut and then use a
> high-speed disc on you die grinder. DO NOT attempt to cut the braided hose
> with a hacksaw. Second, unravel the braid a little and make sure the
> ferule(sp) sits down squrely between the unraveled braid and the hose
itself.
> I clamp the hose lightly in a vise than tap the ferule into place with a
> small hammer. On a #3 always install the nut before installing the ferule.
>     In addition, always use a little rubber-lube or oil when inserting the
> fitting into the hose and ferule.
>     I just did some #3 hoses on my blower injector plumbing the other day,
> and had no problem once I started using the correct size hose for the
> fittings I have. #3's are kinda different and in a group by
> themselves...........Doug KIng
>


<Prev in Thread] Current Thread [Next in Thread>