You are correct! The original GM Tri-power setups used no idle circuits
on the end carbs and the butterflies closed completely. If there are
idle circuits in the base they must properly adjusted unless plugged off
by the base gasket or other means. Screwing the mixture screws in does
not eliminate the idle circuit.
Tom, Redding CA - #216 D/GCC
ynst wrote:
> Simply plugging the power valve and screwing in the mixture screws doesn't
> work. The whole base needs to be modified to get rid of the idle circuits.
>
> Regards,
>
> Skip Readio
>
>
>
>
> -
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
|