land-speed
[Top] [All Lists]

Plumbing a Holley Carb

To: Land-speed@autox.team.net
Subject: Plumbing a Holley Carb
From: Richard Kensicki <richk@spartajunction.com>
Date: Thu, 06 Mar 2003 20:04:58 -0500
I'm looking for something online about plumbing a carb with a fuel feed 
and fuel return line. Bought an 84 Vette and the original owner replaced 
the FI with a Holley 4779. They put a Holley regulator in the line 
before the carb (the fuel pump runs at 9-13 PSI ) and  capped the 
return. What I remember reading somewhere was running the fuel inlet to 
the carb and then to the regulator then back to the tank. This is from a 
fuzzy memory, don't know if it even can be done on this carb. Something 
about outlets on the carb.

While talking about fuel, any recommendations on a fuel filter that I 
can put up front near the engine? Something easily cleaned or replaced.

RichK

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>