For one of the Porsche's AN conversion fittings, I can't (yet) find what I
need. But the fitting
pictured below is close.
http://www.spacey.net/atravis/fitting2.jpg
If you look at the bottom of the picture I've drawn two red lines. Basically
I'd need the inside 37*
'out' flare changed to a 37* 'in' flare.
Would that be hard for a machinist to do? Or should I keep looking?
-Aron-
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|
