If you have some soft copper and want to make a nice looking job, roll out
ever how much you are going to need. Then anchor one end to something solid and
hook the other end to a come-a-long, wench or something similar and pull on
it, this will straighten the tubing and you will still be able to make nice
bends. Just don't go overboard on the pulling or the tubing will get a little
smaller in diameter. This will make the tubing harder but I don't think you
will
ever have a problem as we done this for many years.
Retired Pipefitter
Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|