That is an urban myth in my book as all engines like small good atomizing
injectors at a high pressure so it does not matter what the fuel is.. IE.
Alky likes.....
It does make the switch to alky easier as the injectors do not have to have
as big an orifice as they would at 40 psi.I generally run between 50 and 72
on most everything and juggle pump capacity by running a bigger injector at
a slightly lower pressure than 72 if need be to buy a little headroom on the
pump if needed.
Dave
----- Original Message -----
From: "Rick Byrnes" <Rick@RBMotorsports.com>
To: "Dave Dahlgren" <ddahlgren@snet.net>; "Bryan Savage"
<basavage@wildblue.net>
Cc: "'LSR'" <land-speed@autox.team.net>
Sent: Saturday, April 19, 2008 10:45 AM
Subject: Re: [Land-speed] Alky Burner and formula Holden ignition
> Dave
> On another subject relative to Alky, I recently heard someone say that
> methanol likes 80 psig injection pressure. On my switch from race gas on
> the efi motor we have been using traditional 40 psig as a set point on a
> non boosted motor.
> Is this higher pressure beneficial?
> I suspect so, because we are flowing two times the fuel, the higher
> pressure will help atomization.
>
> Rick
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|