land-speed
[Top] [All Lists]

Re: [Land-speed] Heat Protection

To: land-speed@autox.team.net, Benn <karhu@california.com>
Subject: Re: [Land-speed] Heat Protection
From: JERRY FOSTER <fosterap@flash.net>
Date: Sun, 22 Feb 2009 07:31:37 -0800 (PST)
How about the spark plug wire shielding.  MSD, Moroso, and a number of
ignition people sell it.  It should cover your quarter inch lines perfectly. 
Jerry in Dallas
 
 

--- On Sat, 2/21/09, Benn <karhu@california.com> wrote:

From: Benn <karhu@california.com>
Subject: Re: [Land-speed] Heat Protection
To: land-speed@autox.team.net
Date: Saturday, February 21, 2009, 7:29 PM

I don't think that foam stuff for pipes is gonna have sufficient high-temp
and radiation resistance--might even be rather flamable.  I'd guess the
subject lines go near the exhaust, perhaps?  You then need radiation
shielding
as much as or more than insulation.  So I'd be thinking metal (with some
sort of liner/spacer just to keep the metal out of contact with the line).
Benn

----- Original Message ----- From: "Elon"
<saltfever@comcast.net>
To: "land-speed submit" <land-speed@autox.team.net>
Sent: Saturday, February 21, 2009 4:46 PM
Subject: [Land-speed] Heat Protection


> Local hardware store for the stuff used to keep your water pipes from
> freezing. Or lay it in a tray and pour the 2-part foam in a can used for
> home insulation if a rigid line is ok.
>
>
>
> From: drmayf
>
> . . . My water injection line is 1/4 od high quality air line. I would
like
> some suggestions for sliding something over it to gie it some heat
> protection.
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>