> Hi all.
>
> With the recent discussion surrounding rebuilds and initial
> startup, I have a related question. In a few weeks, I'll be
> starting the rebuild in my MGB for the first time, and while
> I understand the importance of breaking in a new cam to new
> lifters, how about an original cam and new lifters??
>
> Before I am chastised for doing this, I had the cam checked
> by a machinist I trust, had new bearings pressed in and
> fitted to the cam, and all lobes and lifter faces were smeared
> with gooey Crane cam-lube during assembly.
>
> My father always taught me that it was foolish to use a
> new cam and old lifters, but it was fine to use the reverse.
> What I am wondering is do the same break in rules apply??
>
> -Scott
I heard (probably from the same guy who told my to keep the RPM low and
load high to seat main bearings) that if you have a leaky hydraulic
lifter that you should buy a new one and replace the guts in the old
one with the guts from the new one and reinstall the old one. This way
the cam/lifter mating surface doesn't change. When I did my rebuild, I
found the worn valve train was the main reason the engine was so tired
and I replaced everything with new stuff.
That's what I have heard. YMMV
- -Mark = =o&o
|