In a message dated 2/24/98 3:43:43 PM, dmeadow@juno.com wrote:
>The mounting
>bolt holes match the ones the SU uses exactly. Make sure you get the low
>pressure version, I think it says 2 to 5 lbs., whereas the high pressure
>says 7 to 12 lbs. or thereabouts. If you get the high pressure, you will
>have to install a pressure regulator.
>
>Good luck!
>
>David Littlefield
>Houston, TX
>'62 MGA MkII
>'51 MGTD
>'88 Jaguar XJ-S
Actually SU carbies are designed to run on 3.5 PSI. There is one available in
the 1 to 3.5 PSI range. I always use an SU, but I have one of these little
jewels wired and plumbed in case of pump failure. Never hurts to have
insurance.
Bob Shaw
Lincoln, NE.
Bob Shaw
|