mgs
[Top] [All Lists]

Re: Colortuning a 'B - the saga continues

To: Mike Lishego <mikesl@tartan.sapc.edu>
Subject: Re: Colortuning a 'B - the saga continues
From: Paul Hunt <paul.hunt1@virgin.net>
Date: Fri, 07 Aug 1998 20:07:18 +0000
Mike Lishego wrote:
> 
>     So here's my question, if you're still reading.  Is there any way to
> start over and use a methodical approach to tuning this car?  What would any
> of you do if faced with a car, fitted with fresh HIF-4's that was way out of
> tune?  Thanks for any advice, it seems the car is mad at me.  The gauges
> stopped working (again)...

Mike, since taking the Workshop Manual recommended 'methodical approach' I have 
not had to adjust the roadster mixture or balance for about three years now, 
and 
only slight changes to the idle speed to compensate for plug and point wear, 
reversed back out at the next replacement.

Carbs should be mechanically sound, but you can still get good results with 
some 
wear (thank heavens).

Valves and ignition should be checked and adjusted first, also float height.

Slacken throttle linkages, disconnect choke cable and adjust fast-idle screws 
clear of cams.

Screw both jets up till they are flush with the bridge, then screw them down 
two 
turns.

Start the engine and adjust the idle screws independantly to get a balance.

Adjust both jets up or down by the same amount to get the correct mixture.

Set the clearance between the throttle shaft stop and the choke interconnecting 
rod to .12in, then move each throttle shaft lever downwards until the lever pin 
rests lightly on the lower arm of the fork, and tighten the throttle shaft 
lever 
clamp bolts.

Check that the carbs are still synchronised as the throttle is slightly opened, 
if not check the previous step again.

Reconnect the choke cable, ensure the jets return fully home when the choke is 
pulled out and pushed in, pull out the choke about 1/4" and set the fast idle 
screws so that they open the carbs the same amount (i.e. still synchronised) 
and 
adjust for the recommended fast idle speed.

If ever you have need to adjust the mixture or idle speed again, always adjust 
both nuts/screws by the same amount or you will have to start all over again.

Good luck,
PaulH.



<Prev in Thread] Current Thread [Next in Thread>