mgs
[Top] [All Lists]

Re: Block Stampings

To: neil.cairns@virgin.net, gbaker@customcpu.com
Subject: Re: Block Stampings
From: AEKell@aol.com
Date: Sun, 23 Aug 1998 09:20:30 EDT
In a message dated 98-08-23 04:43:11 EDT, neil.cairns@virgin.net writes:

<<  The bores were
 measured, and pistons graded,( by half-thousandths of an inch,) and
 often the grade was stamped on the lower face of the block, ( the sump,
 or pan >>

Neil, 
Could the piston grade also be stamped on the upper face of the block?  If so
(or not), What would  the number three mean?

Alan

<Prev in Thread] Current Thread [Next in Thread>