mgs
[Top] [All Lists]

Re: Distributor advance curves

To: "Pearson, Tim" <tpearson@westpac.com.au>
Subject: Re: Distributor advance curves
From: keeble <keeble@inwave.com>
Date: Fri, 01 Oct 1999 08:07:47 -0500
Lucas # 40943  BMC # C-BHA 4415
0 degrees dist adv @400 dist rpm
8 degrees dist adv @ 1000 dist rpm 
12 degrees dist adv @ 3200 dist rpm    
> note dist not engine in above spec       
>             
>   doug -59 twin cam
> 
> In case anyone's wondering why I want it, I have a 66 B, recently replaced
> the distributor (flogged bearings) and opted for new rather than rec'od. But
> got sold a 41391 - which apparently is all that is available new now.
> Curve on this does not suit my engine (9.3:1CR, K&N's, mild porting, mild
> cam) - pings under load. (Even with vaccuum advance disconnnected)
> I can get the 41391 recurved, but the bloke wants the curve to work off. The
> 40943 was recommended for factory stage 3/4 engines - which is about the
> same as mine. So it sounds like the correct thing.
> 
> Thanx....
> 
> Tim
> 66B YGHN3-3238
> 
> "I don't suffer from insanity, I enjoy every minute of it"

<Prev in Thread] Current Thread [Next in Thread>