| To: | ccrobins@ktc.com |
|---|---|
| Subject: | Re: Rocker Assembly |
| From: | REasterby@aol.com |
| Date: | Wed, 21 Jun 2000 22:22:34 EDT |
How about #97 in the Moss catalog page 12 "Cylinder Head." There are Two used, one on the front on the rocker shaft & the other on the rear held with a cotter pin. Other area of concern is the oil plug # 94 and #93 on the rear rocker pedestal. Early Aluminum Pedestals also needed washers under the "Holddown Nuts" to prevent galling the Aluminum. Good Luck!! Ray Easterby 72 MGBgt Orig owner 88 Xj 40 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: 325HP 'B' Series Motor in MGB Racer, Kai M. Radicke |
|---|---|
| Next by Date: | Re: Fastest in the west, Bullwinkle |
| Previous by Thread: | Re: Rocker Assembly, Charley & Peggy Robinson |
| Next by Thread: | MG Site-ing, (Scott Regel) |
| Indexes: | [Date] [Thread] [Top] [All Lists] |