It appears he's still around.
Wesley Pace wrote:
> What happened to old Joe Huffacker. Is he still around. Does he have any of
> his old MG stuff.
> ----- Original Message -----
> From: Bullwinkle <firstname.lastname@example.org>
> To: Mick Anderson <email@example.com>
> Sent: Thursday, September 27, 2001 12:01 AM
> Subject: Re: Twin Cam - Re: Twin Cam conrods from engine 1343
> > Mick:
> > On my engine, either a rod bolt came loose or broke. These rod's
> > bolts had special twelve point heads. The engine was dyno tested
> > by Huffacker (sp) a well known US MG engine builder. I don't
> > know if they built the engine or just tested it.
> > In regards to the half speed shaft, I have two pieces minus a one
> > inch section just like yours.
/// firstname.lastname@example.org mailing list
/// or try http://www.team.net/cgi-bin/majorcool