It looks like3 I'm the only one using a 1-3/8. Again, I stand corrected.
It's possible that I've taken mine off with a sloppy-fit socket. But it
From: firstname.lastname@example.org [mailto:email@example.com] On
Behalf Of Telewest (PH)
Sent: Thursday, December 05, 2002 8:35 AM
To: Chris; firstname.lastname@example.org
Subject: Re: help
1 5/16" AF, you'll need a socket. I have found an off-the-shelf 1/2"
non-impact fits in the hub, others have said that the 3/4" drive is too
mine is 1.73" outside diameter.
----- Original Message -----
From: "Chris" <email@example.com>
Sent: Thursday, December 05, 2002 1:39 PM
> does anyone know offhand what size spanner to use on the castellated
> holding the rear wheel bearings onto a tube axle?
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive