I just found a complete (minus carbs) motor for my '67 that I want to buy to
replace the 18V in my car right now. If I buy it, I am planning on driving
my Isuzu Trooper over to get it (about a 5 hour trip).
Any suggestions as to how to load it, I might have no help in moving it. It
is on an engine stand right now, but I would have to take it off of that to
get it in. How much will it weight? 300#?
Once in, there are tie downs in the back to secure it.
Thanks
Patton
-------------------------------------
Patton Dickson - Richmond, TX
1967 MG MGB Mk. I Roadster
1965 Corvair Monza 110/4sp 'vert
Website - http://carport.virtualave.net/
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|