I have wires but am pretty sure they are pressed into the drum from the rear
side, similar to US cars, and probably have a spline and head to prevent
them from spinning and pulling out when tightening the lugnuts.
----- Original Message -----
From: "S. Allen" <email@example.com>
Sent: Monday, October 18, 2004 4:34 PM
Subject: Stud Question
> I snapped off one of the wheel studs on the rear of my 74 1/2 today,
> (Rostyle rims, not wire) and I was wondering how hard they are to
> replace as the manual and expoded drawings aren't too clear.
> Can you just pop them out after removing the brake drum or do you need
> to remove the half shaft to get at them?
> I'm hoping it's the former rather than the latter...
> Any help appreciated,
> Scott Allen
> 74 1/2 BGT
> 52 TD
Check out the new British Cars Forum: