Speedo Head Right Angle DriveI *think* it goes through the bulkhead the same
for RHD and LHD - on top of the footrest/starter bulge in the RH footwell. In
the case of RHD it comes straight up and curves gently backwards straight into
the back of the speedo. For an LHD it curves left (facing forwards) behind
the dash to reach the speedo, and without the right-angle drive has to take
quite a sharp turn backwards into the back of the speedo, it also needs a
longer cable.
PaulH.
----- Original Message -----
From: Christian, Skip
To: paul.hunt1@blueyonder.co.uk
Cc: MG Digest (E-mail)
Sent: Thursday, January 20, 2005 1:30 PM
Subject: Speedo Head Right Angle Drive
From what you say below, it sounds like my cable is not routed
correctly. I do not have the right angle drive at the top, but there is no
sharp bend in the cable. Here's my question - where should the speedo cable
pass through the engine compartment bulkhead ?? Or is this cable even
supposed to pass through the engine compartment ?? I can't imagine where it
would go with a right angle drive attached.... right, left, down ?
|