mgs
[Top] [All Lists]

Re: Oil Line Routing

To: "Paul Hunt" <paul.hunt1@blueyonder.co.uk>,
Subject: Re: Oil Line Routing
From: "Rich C" <richchrysler@quickclic.net>
Date: Fri, 20 Jan 2006 10:52:01 -0500
Hello all,
I was finally able to determine where the oil pressure line routes and 
enters the interior of this LHD '66 B.
>From the brass fitting on the engine compartment bulkhead, the line goes 
back and immediately turns inboard, does virtually a 180 degree turn, comes 
forward, drops down over the edge of the horizontal plane, turns down and 
outboard and enters through a grommet in the upper inboard side of the right 
side foot well. from there it stays up high and goes toward the back of the 
car, turns inboard and goes across the inner centre bulkhead, staying above 
the fresh air trap door, then turns towrd the back of the instrumnet panel 
and enters the back of the oil pressure gauge. It appears to have a couple 
of P clips securing it to the bulkhead along the way.


Rich Chrysler 




<Prev in Thread] Current Thread [Next in Thread>
  • Re: Oil Line Routing, Rich C <=