No, heating an installed ring gear will heat up the flywheel as well as the
ring gear. Since both of them are steel they will both expand at the same
rate.
What you will end up with is a very hot flywheel that still has a ring gear
on it. Not the result you are looking for. :-) It has been years since I
did a B flywheel, but cut with the hacksaw and hit it with a bloody big
chisel and hammer always worked for me.
On 6/27/08, Max Heim <max_heim@sbcglobal.net> wrote:
>
> You are suppose to heat it red hot to get it on, according to the manual.
> Wouldn't it work the same way getting it off?
>
>
> --
>
> Max Heim
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|