[Top] [All Lists]

Re: [Mgs] Can't remove clutch slave components

To: "Steve Shoyer" <>, <>
Subject: Re: [Mgs] Can't remove clutch slave components
From: "PaulHunt73" <>
Date: Wed, 9 May 2012 11:48:39 +0100
List-archive: <>
List-help: <>
List-id: MG Sports Car discussion <>
List-post: <>
List-subscribe: <>, <>
List-unsubscribe: <>, <>
References: <2CA312BA0390476CB037CD0B8A864F73@SteveLenovo>
It's a beggar unless you take the engine out!  Removing the starter might 
give you more access.  Failing that I'd cut the hose off then grind the 
fitting off from the bottom of the bracket which should allow you to lift 
the top part of the fitting away from the bracket and pull it down a bit to 
give better access to the two parts that are normally above the bracket. 
Worst case scenario is that you have to replace the pipe from master to 
bracket as well.  If you give up on the hose and just replace the slave you 
will probably find that with the slave screwed onto the hose the slave 
brackets no longer line up with the bell-housing as the thread start is 
almost certainly in a different place.  I was lucky, an additional copper 
washer lined it up again, you don't want to bolt it on with the hose 
twisted.  What was really annoying is that I'd only just put the engine back 
after a clutch change, only then finding that the slave had started leaking.

You may not need to remove the clevis pin, the push-rod coming out of the 
rubber boot simply sits in an indentation in the outer face of the piston, 
it's not attached.  You should be able to get away with using the old 
push-rod as long as it is the same length as the new.


----- Original Message ----- 
> I'm trying to replace my clutch slave cylinder, as well as the hose 
> leading
> to it, but I can't loosen the fitting on the pipe that connects to the
> clutch hose.  I'm afraid of breaking the pipe if I use too much force on 
> the
> wrench.  I sprayed the area with B'laster, which hasn't made any 
> difference
> yet.
Suggested annual donation  $12.75

<Prev in Thread] Current Thread [Next in Thread>