I had to heat mine with an oxy-acetylene torch and then beat the snot out of
it. It has a tapered spline that sometimes won't come out easily.
>I am trying to remove the brake master cyclinder on my 1957 3600. I removed
>the bolts and brake lines but I have been unable to get the curved brake
>pedal arm coming through the floorboards to separate from the pivot arm
that
>actuates the master cylinder. It is almost impossible to get an angle where
a
>5 lb hammer can be much help. Anyone else know of a way to get this to let
>go? I am almost at the point of sawing the brake pedal off of the arm and
>trying to reatttach it later. Help!
>
>Rick in Iowa
>57 3600 (took 3 trips to get it all home)
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|