Chassis Engineering Inc. sells a weld-in Pinto/Must.II IFS kit for '40-'46
Chevy/GMC trucks. Part # IF-4046PM for $420.00 It uses '74-'80 Pinto or '74-'78
MII components. I've had good luck with their parts, mainly engine mounts and
their service over the phone was great. They are located in Iowa, their phone #
is (319) 643-2655 Hope this helps.
Jeff Street- Seattle, WA
'55-2 short/step "Street's rod project"
> I''m rebuilding a 1941 pickup, but not to its orginal state, far from it !!
> My first step was to tear it all apart, done. I want to stuff a 350 moter in
> it with an auto trans.I also want to fabricate a different front end under
> it, I here the mustang II is the way to go. I defiantly want power disk
> breaks and steering, that should be fun trying to stick that all under that
> small hood !! HUH ?
> Is there anyone that might be able to give me any suggestions, like what
> years of a mustang to get for the front end. I'll take any suggestions on
> anything...pertaining to the rebuild of this truck. Thanks, Tim
> Tim Tozer
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959