Same for my 57, however I know there are schematic differences between 57 and
58.
The 57 has no in-line fuse for the turn signals. My guess would be that you
have
the wrong flasher. 57 GMC's single turn signal lamp in the dash runs directly
from
the third pin on the flasher.
-----Original Message-----
From: Blaine Dumkee [mailto:bmdumkee@auroranet.nt.ca]
Sent: Monday, May 27, 2002 10:58 PM
Cc: oletrucks
Subject: Re: [oletrucks] 58 GMC turn signal questions
What do you mean by indicator light? If you mean the small round light in
the dash, then my 59 GMC only flashes when the turn signals are on.
----- Original Message -----
From: "larry jones" <lajones@uswest.net>
To: <napco4x4@yahoogroups.com>
Cc: "oletrucks" <oletrucks@autox.team.net>
Sent: Monday, May 27, 2002 1:47 PM
Subject: [oletrucks] 58 GMC turn signal questions
> Fellow GMC owners,
> I have a couple of questions about the turn signals on my 58 GMC
> NAPCO Carryall.
> First of all, should the turn signal indicator light always be on when
> the ignition is on? I don't remember if it was that way before I
> replaced the flasher when it burnt out. There is an inline fuse in the
> harness for the flasher. Does anyone know what size fuse to use? I
> looked at the shop manual wiring diagram, and I see where there should
> be a fuse, but I can't find the size. Thanks for any ideas.
>
> Larry Jones
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|