oletrucks
[Top] [All Lists]

Re: [oletrucks] IFS for a Chevy 1 ton

To: "Wayne Roworth" <wroworth@hotmail.com>,
Subject: Re: [oletrucks] IFS for a Chevy 1 ton
From: "Steve Hanberg" <steve@OldSub.com>
Date: Fri, 17 Jan 2003 11:42:29 -0800
I think I would investigate using the IFS from a 3/4 ton '73 - '87 pickup.
The crossmember and suspension from a 1/2 ton is supposed to be an easy swap
to an AD 1/2 ton pickup...

I think someone on the list investigated and decided the stuff I'm
suggesting was too wide, but I don't recall exactly what they said.

----- Original Message -----
From: "Wayne Roworth" <wroworth@hotmail.com>
To: "OLE Trucks List" <oletrucks@autox.team.net>
Sent: Friday, January 17, 2003 8:19 AM
Subject: [oletrucks] IFS for a Chevy 1 ton


> Hello all,
>
> This list is very informative and I want to thank you all!
>
> I am considering replacing my stock 47 Chevy Panel 1 ton, 8 lug, 16" rim,
> suspension. The engine is not stock, a chevy small block V8. Turbo 400
trans
> with cooler. Brakes are assisted drums.
>
> I have read Jack Halton's Pacer IFS document on the subject and am
visiting
> him this Saturday to discuss further. Great article by the way.
>
> I have seen the Mustang II's and cost is a factor.
>
> My concern is:
>
> The lug patterns, disc brake sizes, etc., are considerably smaller than
the
> stock truck. Since I haul my boats, I am concerned if I will have enough
> stopping power. I don't plan on loading up the truck's interior since it
will
> be for show only but I want to make sure my IFS conversion will be safe.
>
> Also, knowing that the rims will change, will I be able to adapt a smaller
rim
> to the non-stock rear axle. The rear end is from a 1971 1 ton single rear
> camper with 411 gears.
>
> Any comments will be greatly appreciated.
>
> Thank you...Wayne
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>